Skip to main content
Tiler setting large-format wall tile, bathroom remodeling in Washington, DC
Serving Washington, DC

Bathroom Remodeling Contractor in Washington, DC

Most DC row house bathrooms sit over the kitchen on a century-old cast iron stack, so the stack and the joists get checked before we price.

What Bathroom Remodeling Work in Washington Involves

One bathroom, one stack

Most District row houses have one bathroom on the second floor, over the kitchen on a shared cast iron stack that is now a century old and often behind slow drains and odd smells. A full remodel is the time to replace it. A second bathroom ties into that stack or needs a new one, and the joists decide how easy that is.

Waterproofing is the part you never see again

With neighbors on both walls, a leaking shower does not stay your problem. The pan, membrane and flood test happen before tile, and you can see them. Plumbing goes on a Department of Buildings permit with a licensed plumber, and a basement bathroom below sewer level needs an ejector pump, priced from the start.

A DC bathroom remodel is a plumbing decision

In the row houses around Lincoln Park, in Trinidad near Gallaudet University and near the Frederick Douglass National Historic Site, the bathroom sits on wall-to-wall joists beside a century-old stack.

Choose the layout once the pipes and joists are understood. Tile and fixtures are the easy part.

The local concept

The Joist Run

The joist run is the direction the floor joists span under your bathroom, almost always from one party wall to the other in a row house.

A drain that runs along the joists is easy. A drain that has to cross them means notching, sistering or dropping a ceiling below, so the joist run decides where the toilet and shower can go.

What DC homeowners want from their bathroom

Replacing the original bathroom

The single upstairs bath gets stripped to the joists, the cast iron stack replaced, and a new shower waterproofed before tile.

Tub to walk-in shower

Swapping the tub for a walk-in shower is common in narrow bathrooms. The drain moves, so the joist run decides how big the shower can be.

A second bath from a closet or bedroom corner

A closet that backs onto the stack is often the cheapest place for a second bathroom in a row house.

Basement bathrooms

A bath below the sewer line needs an ejector pump. It is planned and priced in the first estimate.

Curbless showers for staying put

A curbless shower with blocking for grab bars lets you stay in the house longer. The floor is recessed so water stays in the shower.

Fans that vent outside

Many older DC bathrooms have no fan, or one that dumps into the attic. A new fan is ducted outside so moisture stops reaching the plaster and the joists.

What a DC bathroom remodel covers

  • Cast iron stack replaced while the walls are open
  • Drain routes planned around the joist run
  • Shower pans, membranes and flood tests before tile
  • Ejector pumps for baths below the sewer line
  • Curbless showers and grab-bar blocking
  • Licensed plumbing under a Department of Buildings permit

Our route to your DC bathroom

Our crew comes from Bryans Road, Maryland, about 17 miles south of the District in a straight line.

They drive up MD 210, take I-295 north along the Anacostia, and use DC 295 to reach Deanwood, Trinidad and the Northeast neighborhoods.

Map of Washington, DC bathroom remodeling area and the route from All Purpose Remodelers in Bryans Road, MDWashington, DC is shaded, with Lincoln Park, Gallaudet University and the Frederick Douglass National Historic Site marked. A dashed line runs about 17 miles south to the shop in Bryans Road, Maryland. The route follows MD 210 north, I-295 along the Anacostia and DC 295 into Northeast.Potomac RiverAnacostia RiverPatuxent RiverOccoquan RiverMD 210I-295DC 295about 17 milesLincoln ParkGallaudet UniversityFrederick Douglass National Historic SiteWashington, DCAll Purpose RemodelersBryans Road, MD5 milesN
© OpenStreetMap contributorsGet directions

Areas Served Around Washington

Capitol HillColumbia HeightsPetworthBrooklandShawBloomingdaleTrinidadAnacostiaDeanwoodMount Pleasant

Washington Remodeling Questions

Can you add a second bathroom to a DC row house?

⌄
Yes. The common places are the basement, a corner of the back bedroom, or a closet that backs onto the existing stack. Where the joists and the stack run decides which is cheapest, and we tell you at the walkthrough.

Do I need a permit for a bathroom remodel in DC?

⌄
If plumbing or electrical moves or is added, yes, from the Department of Buildings, with the plumbing done by a licensed plumber. Swapping fixtures in the same places generally does not. The written scope names which applies and who pulls it.

Should I replace the cast iron stack during my bathroom remodel?

⌄
If it is original and the walls are already open, it is the best time. We look at its condition at the walkthrough and price it as a line item so you can decide.

Can my DC bathroom have a curbless shower?

⌄
Often, if the joists allow the floor to be recessed. If they do not, a low-threshold shower is the next best option, and we show you both.

Do you work in Trinidad, Deanwood and Anacostia?

⌄
Yes. Every quadrant of the District is inside our service area.

Does my DC bathroom need an exhaust fan?

⌄
If it has no window that opens, yes, and it is a good idea anyway. We duct it to the outside, not into the attic or the wall.

Can a clawfoot tub go back in after the remodel?

⌄
Yes, if the floor framing is sound. A cast iron tub full of water is heavy, so we check the joists under it and add support where needed before it goes back.

Start My Estimate in Washington

Fill out the form below or call (240) 695-4415 to talk it through. We answer every day, 7:00 AM to 7:00 PM.

We take insurance jobs. Financing may also be available for qualifying projects. Ask when you call.